Programming Forums > Application Development > Assembly

Cineno · Dec 8th, 2004, 5:35 PM

Hey guys, I have need some help with this one:

I have to make a program in SPIM that takes in assembly code from the user and outputs it's hexadecimal equivilant. Basically, it's a model assembler. I'm having a lot of problems with it. My code isn't even enough to post because I don't know where to begin! Any help is greatly appreciated.

Note: it's not a full assembler, it only has to work for 8 instructions.

thechristelegacy · Dec 8th, 2004, 7:58 PM

If you want help, post what you have, and don't worry about it not being good enough

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Dec 8th, 2004, 5:35 PM	#1
Cineno Newbie Join Date: Dec 2004 Posts: 1 Rep Power: 0	Hey guys, I have need some help with this one: I have to make a program in SPIM that takes in assembly code from the user and outputs it's hexadecimal equivilant. Basically, it's a model assembler. I'm having a lot of problems with it. My code isn't even enough to post because I don't know where to begin! Any help is greatly appreciated. Note: it's not a full assembler, it only has to work for 8 instructions.

Dec 8th, 2004, 7:58 PM	#2
thechristelegacy Expert Programmer Join Date: Jul 2004 Location: Somerset, Pa Posts: 708 Rep Power: 5	If you want help, post what you have, and don't worry about it not being good enough

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Programming Forums > Application Development > Assembly

Mips Question